Mechanically mix slowly for 3 to 5 minutes. If patching is required, consult Euclid Chemical Technical Support for appropriate patching materials. Any warranty claim must be made within one 1 year from the date of the claimed breach. Although compatible with other Euclid Chemical solvent-based curing and sealing products, best results are obtained when applying Luster Seal on bare, unsealed concrete. Avoid applying to excess which can cause the product to run down the wall or puddle. Applicable for individual chemicals only for exposure at room temperature to coatings applied at a minimum film thickness of 40 mils. Following surface preparation, the cleaned surface should pull concrete when tested with a pull tester, or an elcometer ASTM D
Tags amusement parks Euclid Beach parks. Image Courtesy of Cleveland State University. Clean-Up Clean tools and application equipment immediately after use with detergent and hot water. Remove any surface hardener or curing compound, by mehcanical abrasion. A mortar consisting of the overlay resin and aggregate may be required for broadcast overlays. When applying to new stamped concrete, the surface must be free of all unbonded release agent powder or liquid residue. Secure the attachment until the epoxy sets.
Dissipation begins approximately 4 to 6 weeks after application. If you have to spray tinted EverClear, it is good practice to put 2 golf balls in the sprayer and shake frequently to help keep the color packs in suspension. After removing the excess Super Diamond Clear, a roller can be used to redistribute the remaining product evenly across the surface, adding more solvent as necessary to keep the sealer wet. For oil contaminated surfaces, use steam cleaning in combination with a strong emulsifying detergent. Defective concrete, honeycombs, cracks, cavities and other defects should be routed to sound concrete and patched using compatible materials. Always follow directions and warning labels on solvent or stripper containers. Mix thoroughly for approximately 3 minutes.
This high modulus, low viscosity epoxy resin is the perfect solution for general bonding applications and for injecting cracks in concrete and a variety of other substrates. The surface should be lightly sand blasted, shot blasted or water blasted with a minimum pressure of 5, psi Standard colors are light gray, dark gray, tile yes yes red, and clear. A second coat may be applied depending upon the desired surface gloss. The surface porosity and the amount of surface sheen desired determines the selection of material for the second coat. For oil contaminated surfaces steam cleaning in conjunction with strong emulsifying detergent is recommended. Most Euclid Chemical systems do not require a primer, but there are certain application and environmental conditions in which a primer can increase the likelihood of a successful project.